Multicomponent bionanocomposites based on clay nanoarchitectures for electrochemical devices

• Giulia Lo Dico,
• Bernd Wicklein,
• Lorenzo Lisuzzo,
• Giuseppe Lazzara,
• Pilar Aranda and
• Eduardo Ruiz-Hitzky

Beilstein J. Nanotechnol. 2019, 10, 1303–1315, doi:10.3762/bjnano.10.129

• fibrous clay, together with ultrasonication, is the key to disperse all these components in water. The resulting stable colloids can be processed as films and foams displaying acceptable mechanical properties, good electrical conductivity, and controlled porosity useful for diverse applications at the

On the transformation of “zincone”-like into porous ZnO thin films from sub-saturated plasma enhanced atomic layer deposition

• Alberto Perrotta,
• Julian Pilz,
• Stefan Pachmajer,
• Antonella Milella and
• Anna Maria Coclite

Beilstein J. Nanotechnol. 2019, 10, 746–759, doi:10.3762/bjnano.10.74

• , development of controlled porosity, and formation and growth of ZnO crystallites. The layers developed controlled nanoporosity in the range of 1–5%, with pore sizes between 0.27 and 2.00 nm as measured with ellipsometric porosimetry (EP), as a function of the plasma dose and post-annealing temperature

• the one of pure ZnO deposited under saturation conditions (1.858 ± 0.003 at 633 nm), indicating a low amount closed porosity included in the final ZnO matrix. The layers deposited with intermediate plasma exposure times (2 s) showed the development of controlled porosity as a function of the

Block copolymers for designing nanostructured porous coatings

• Roberto Nisticò

Beilstein J. Nanotechnol. 2018, 9, 2332–2344, doi:10.3762/bjnano.9.218

• cracks induced by the solid templates [115]. Furthermore, the continuous development of novel functional substrates with highly controlled porosity is an increasing field of research that involves worldwide experts from both academia and industry. According to the works summarized in this review, the

Surface-enhanced Raman scattering of self-assembled thiol monolayers and supported lipid membranes on thin anodic porous alumina

• Marco Salerno,
• Amirreza Shayganpour,
• Barbara Salis and
• Silvia Dante

Beilstein J. Nanotechnol. 2017, 8, 74–81, doi:10.3762/bjnano.8.8

• carrier layer for local drug delivery [24], as a substrate for living cell cultures thanks to its controlled porosity [3][4][5][6][7], and for SERS [25]. However, since SERS is a surface-only effect, this sensitive detection will be limited to the top of the tAPA–Au substrates, i.e., to the bottom of the

Polystyrene-block-poly(ethylene oxide) copolymers as templates for stacked, spherical large-mesopore silica coatings: dependence of silica pore size on the PS/PEO ratio

• Roberto Nisticò,
• Giuliana Magnacca,
• Sushilkumar A. Jadhav and
• Dominique Scalarone

Beilstein J. Nanotechnol. 2016, 7, 1454–1460, doi:10.3762/bjnano.7.137

• between the hydrophilic/hydrophobic ratio of the two polymer blocks and the size of the final silica pores. The obtained results prove that by tuning the PS/PEO ratio, the pore size of the templated silica films can be easily and finely predicted. Keywords: block copolymers; controlled porosity

Functionalized nanostructures for enhanced photocatalytic performance under solar light

• Liejin Guo,
• Dengwei Jing,
• Maochang Liu,
• Yubin Chen,
• Shaohua Shen,
• Jinwen Shi and
• Kai Zhang

Beilstein J. Nanotechnol. 2014, 5, 994–1004, doi:10.3762/bjnano.5.113

• first reports on mesoporous silica MCM-41 [9], inorganic oxides with controlled porosity have been extensively investigated. It is known that mesoporous photocatalysts usually exhibit high specific surface areas that can provide more surface reactive sites. The nanoscale channel walls of mesoporous

Preparation of electrochemically active silicon nanotubes in highly ordered arrays

• Tobias Grünzel,
• Young Joo Lee,
• Karsten Kuepper and
• Julien Bachmann

Beilstein J. Nanotechnol. 2013, 4, 655–664, doi:10.3762/bjnano.4.73

• electrochemical cycling. A Si electrode displaying a controlled porosity could circumvent the difficulty. In this perspective, we present a preparative method that yields ordered arrays of electrochemically competent silicon nanotubes. The method is based on the atomic layer deposition of silicon dioxide onto the